A0600/hpux/INSTALL
revision: 97-11-06
----------------------------------------------------------------------

HP ELOQUENCE A.06.00 - Installation Instructions
================================================

HP Eloquence can only be installed and run on HP-UX Operating 
System Release 9.0 or later. 
HP Eloquence A.06.00 will be installed in the /opt/eloquence6
directory and will not affect any previous HP Eloquence revision.

Installing on HP-UX 9.x:
------------------------

   As "superuser," follow the steps below to install the HP Eloquence
   software.

   1. Mount the CD-ROM

         mount /dev/dsk/c3d0s2 /cdrom

      where /dev/dsk/c3d0s2 is the device file associated with the
      CD-ROM drive and /cdrom is the directory where the CD-ROM should
      be mounted.

   2. Run update(1m) by typing:

         /etc/update

   3. Select "Change Source or Destination ->".

   4. Select "From Tape Device to Local System ...".

   5. Tab to the "Source" field and enter the following:

         /cdrom/A0600/HPUX/B1368B.UPDT;1

       where /cdrom is the directory where the cdrom is mounted. 
       Because HP-UX does not support the Rock-Ridge CD-ROM 
       extensions, file names are upper case with a trailing ;1.

   6. Press "Done".

   7. Select "Select/View Partitions and Filesets ..."

   8. Activate the B1368B partition to install the HP Eloquence 
      product.

   9. Select "Start Loading".

   10. Type "y" to "Start loading filesets now?".

   11. Check /tmp/update.log to make sure installation completed 
       with no error.


Installing on HP-UX 10.x:
-------------------------

   As "superuser," follow the steps below to install the HP Eloquence
   software.

   1. Mount the CD-ROM

         mount /dev/dsk/c1t2d0 /cdrom

      where /dev/dsk/c1t2d0 is the device file associated with the
      CD-ROM drive and /cdrom is the directory where the CD-ROM should
      be mounted.

   2. Run "swinstall" by typing:

         /usr/sbin/swinstall -s /cdrom/A0600/HPUX/B1368B.SD\;1

       where /cdrom is the directory where the cdrom is mounted. 
       Because HP-UX does not support the Rock-Ridge CD-ROM 
       extensions, file names are upper case with a trailing ;1.
       Please note, that the ';' has a special meaning to the shell
       and must be escaped with a backslash.

   3. In the Software Selection Window, highlight to select the
      "B1368B" product to install the HP Eloquence product, then
      choose the "Mark for Install" item from the Actions Menu. 
      The "Marked?" column will automatically be set to "Yes". 

   4. Select the "Install (analysis...)" item from the Actions Menu.
      When the analysis is finished with no error, i.e. Status:Ready, 
      click OK.

   5. Click Yes in the Confirmation window to begin the actual
      installation process.

   6. When the installation is completed, a dialog is displayed to 
      notify you that the install task is completed.  You may exit then.